Cable connector to connect two 12 volt low-voltage cables in a split cable plan.
Enables branching in the cable plan
Maximum capacity of 50 watts after the CC-2
For using multiple CC-2s in a cable plan
Installation advice:
Place the CC-2 so that it can be accessed easily
In stock
Art. nr.
10600701
Shopping by appointment
Would you like a closer look at this product or are you looking for advice from a lighting specialist? Then make an appointment with an in-lite retailer here. After completing the form below, you will be contacted a.s.a.p. to make an appointment in the shop. If the appointment is not convenient for you, we will look for an alternative.
Would you like a closer look at this product or are you looking for advice from a lighting specialist? Then make an appointment with an in-lite retailer here. After completing the form below, you will be contacted a.s.a.p. to make an appointment in the shop. If the appointment is not convenient for you, we will look for an alternative.
Something went wrong. Please check entered data and try again.
Cable connector to connect two 12 volt low-voltage cables in a split cable plan. Filled with moisture-resistant gel. Maximum load 50 VA.
Specs
Art. nr.
10600701
EAN code
8717051002403
Order unit
10
Article group
Cables
Installation instructions
Installation advice
Load a cable connector with up to 50 VA. If you have placed 60 watts of fixtures after the branch-off, then you use 2 cable connectors. Make sure that the ribbed and smooth side of the cables to be connected points to the same side.
