Cover caps to neatly finish the end of the cable. Set of 20 pieces.
Easy to assemble and disassemble
Supplied with the transformer as standard
Easy to install and uninstall
In stock
Art. nr.
10600905
Shopping by appointment
Would you like a closer look at this product or are you looking for advice from a lighting specialist? Then make an appointment with an in-lite retailer here. After completing the form below, you will be contacted a.s.a.p. to make an appointment in the shop. If the appointment is not convenient for you, we will look for an alternative.
Would you like a closer look at this product or are you looking for advice from a lighting specialist? Then make an appointment with an in-lite retailer here. After completing the form below, you will be contacted a.s.a.p. to make an appointment in the shop. If the appointment is not convenient for you, we will look for an alternative.
Something went wrong. Please check entered data and try again.
Cover caps to neatly finish the end of the cable. Set of 20 pieces. Please note! Our transformers come standard with the required numbers of CABLE CAP STANDARD for the 14/2 cable and CABLE CAP MEDIUM for the 10/2 cable.
Specs
Art. nr.
10600905
EAN code
8717051003677
Order unit
1
Article group
Cables
Installation instructions
Installation advice
Pull the last three centimetres of the cable apart and place a cap on each end. Do not remove any insulation material from the cable. To install our system and fittings, read the manual or watch the instruction videos.
